Werbung
Verfügbare Sprachen
Verfügbare Sprachen
What
to Do When
the Alarm
Sounds
1.Call emergency servicesassoon as possible.
2. Immediate y move outside and make sure that everyone inside the house hasevacuated the area or hasaccessto fresh air.
Do not re enter the house until it has been aired out and your alarm remains under normal condition. If it is not possibleto
move outside, stay close to an open door/window until emergency service responders arrive,
3. After fol owing steps 1-2 above, if your alarm reactivateswithin a 24 hour period, repeat steps 1-2 and cal a qualified
appliance technician to investigate sources of CO from fuel-burning equipment and appliances,and inspect for proper
operation of this equipment.
4 f prob ems are identified during this inspection, havethe equipment serviced immediately. Note any combustion equipment
that hasnot been inspected by the technician and consult the manufacturer's instructions, or contact the manufacturers
direct y for more information about COsafety and this equipment. Make sure that motor vehicles are not, and have not been,
operating in an attached garage or adjacent to the residence
Maintenance
To keep your alarm in good working order, you should adhere to the following steps.
)
30
1 Test the alarm once a week by pressing the test/silence button,
2. Vacuum the alarm cover once a month to remove any accumulated dust.
3. Never usedetergents or solvents to clean the alarm. Chemicalscan permanently damage or temporarily contaminate the
sensor.
4. Avoid spraying air fresheners, hair spray,paint or other aerosols nearthe alarm.
5, Do not paint the unit. Paint may clog the openings to the sensing chamber and prevent the unit from operating properly.
A WARNING
DO NOT TAMPER WITH THE APPARATUS, AS THERE IS A RISK OF ELECTRIC SHOCK OR MALFUNCTION.
Battery Replacement
Removethe old battery and rep acewith a CR123Abattery when the LCDdisplaysthe "Lb" message and the LED indicator
flashesyel ow once every60 seconds with the buzzer chirping.
When the battery is replaced and the device is turned on, the alarm will beep once while the LEDflashes red Then,the LED
indicator wil begin flashing blue until the Wi-Fi connection is successful.Ifthe LEDindicator flashesfor 2 minutes and then
Stops,this indicatesthe Wi Ficonnection hasfailed.
.31.
Werbung
