x-sense XC04-WX Bedienungsanleitung Seite 13

Alarm Mode)
When the device detects CO,and the CO ppm reachesa certain level for a period of time, the unit wil sound an alarm, beep 4
times every5.8 seconds,and the LEDwill flash red.The app will show a "COAlarm Triggered" notification, and an app push
notification will be sent to your smartphone. The CO concentration is shown through the in-app message and push
notifications. You can also check the COconcentration in the history section of the app.
When the carbon monoxide concentration drops be ow the alarm threshold, the alarm sound will stop, and the LEDwill flash
green once every second for 5 seconds.Then, it will automatically enter standby mode, When the alarm ends, an app push
notification will be sent to your smartphone.
Silence Mode.
f there is a false alarm, you can temporarily silence it by pressing the test/silence button on the device or in the app. You will
receive an instant notification from the app telling you that the device hasbeen temporarily silenced.The LEDwill flash red4
times every5.8 seconds to remind you that the alarm has been silenced,The alarm will automatically exit silence mode after 9
minutes.
• 22 •
During silence mode, if the carbon monoxide concentration is still greater than 50 ppm after 6 minutes, the device wil be
triggered again; if not, the device will automatica y exit the silence mode after 9 minutes, and the LEDwil flash green 3 times
continuously.
LCD Display
While detecting CO,the LCDwill display different indicators to inform you of the alarm status, as shown below.
Mode LCD Display
Irst-tme use
n ng
without
on
connecting to
the Wi-Fi.
LED Indicator Audible Alarm Remarks
Runsthrough 8 cycles 1 quick beep. Make sure the battery
(ye ow/green/red) in insulating film is
removed
sequence.
device
• 23 •
and the
is turned on.