Adjusting The Length Of The Stainless Steel Nozzle Pipe; Adjusting The Cone Spray Head On The Stainless Steel Nozzle Pipe; Attaching The Plastic Nozzle Pipe; Attaching The Nozzle Accessories - Parkside Performance Pprds 20-Li C3 Bedienungs- Und Sicherheitshinweise

˜ Adjusting the length of the
stainless steel nozzle pipe
(Fig. H)
NOTE
Adjust the length of the stainless
u
steel nozzle pipe
contaminating yourself, bystanders
or the environment.
The stainless steel nozzle pipe
be telescoped out.
Extending the stainless steel nozzle
pipe :
[ 9 ]
1. Turn the pipe nut
anti-clockwise direction until it is
loose.
2. Pull out the stainless steel nozzle
pipe by the tip until it reaches the
[ 9 ]
desired length.
3. Turn the pipe nut
direction until it is tight.
NOTE
To avoid contamination of
u
environment, operator or
bystanders, extend the length of
the stainless steel nozzle pipe
necessary.
˜ Adjusting the cone spray
head on the stainless steel
nozzle pipe
Fig. J
The cone spray head
on the stainless steel nozzle pipe
Adjusting the spray pattern
Jet: Turn the tip of the cone spray
o
head in an anti-clockwise
[ ]
direction (loosen the cone spray
head).
Mist: Turn the tip of the cone spray
o
head in a clockwise direction
[ ]
(tighten the cone spray head).
56 GB/IE
to avoid
9 ] [
can
9 ] [
in an
[ ]
in a clockwise
[ ]
if
9 ] [
is pre-installed
[ ]
.
9 ] [
˜ Attaching the plastic nozzle
pipe
Fig. K, L
Connect either end of the plastic
nozzle pipe
[ ]
valve .
[ ]
Push the O ring
and the union nut
thread on the shut o valve
Turn the union nut
direction until it is tight Fig. G .
˜ Attaching the nozzle
accessories
The nozzle accessories
assembled only with the plastic nozzle
pipe .
[ ]
The nozzle accessories are not to be
assembled with the stainless steel
nozzle pipe .
9 ] [
Insert the desired nozzle
o
accessory into one end of the
[ ]
plastic nozzle pipe
Push the O ring
o
and the union nut
thread on the nozzle accessory
Turn the union nut
o
direction to tighten it on the thread of
the nozzle accessory
Choosing the suitable nozzle
accessory
Nozzle Application
Fan nozzle Uniform spray pattern
Double Spraying large areas
head Spraying large crops
nozzle High ow rate
Single
Spraying small areas
head
Spraying large crops
nozzle
Mist Spraying mist
nozzle High ow rate
to the shut o
, security ring
[ ] [
towards the
[ ]
.
[ ]
in a clockwise
[ ]
are to be
[ ]
.
[ ]
, security ring
[ ] [
towards the
[ ]
[
in a clockwise
[ ]
.
[ ]
]
]
.
]