Parkside Performance PBSPA 12 C3 Originalbetriebsanleitung Seite 21

b) Use personal protective equip-
ment. Always wear eye protec-
tion.­Protective­equipment­such­as­dust­
mask,­non-skid­safety­shoes,­hard­hat,­
or­hearing­protection­used­for­appro-
priate­conditions­will­reduce­personal­
injuries.­
c) Prevent unintentional starting.
Ensure the switch is in the off-
position before connecting to
power source and/or battery
pack, picking up or carrying the
tool.­Carrying­power­tools­with­your­
finger­on­the­switch­or­energising­pow-
er tools that have the switch on invites
accidents.
d) Remove any adjusting key or
wrench before turning the pow-
er tool on. A wrench or a key left at-
tached­to­a­rotating­part­of­the­power­
tool­may­result­in­personal­injury.­
e) Do not overreach. Keep proper
footing and balance at all times.
This­enables­better­control­of­the­power­
tool­in­unexpected­situations.­
f) Dress properly. Do not wear
loose clothing or jewellery. Keep
your hair, clothing and gloves
away from moving parts. Loose
clothes,­jewellery­or­long­hair­can­be­
caught­in­moving­parts.­
g) If dust extraction and collection
devices can be installed, make
sure that these are connected
and used correctly. Use of dust
collection­can­reduce­dust-related­haz-
ards.
h) Do not allow yourself to be
lulled into a false sense of se-
curity and do not disregard the
safety rules for power tools,
even if you are familiar with the
power tool after using it many
times. Careless action can lead to
serious­injuries­within­a­fraction­of­a­
second.
4) POWER TOOL USE AND CARE
a) Do not force the power tool. Use
the correct power tool for your
application.­The­correct­power­tool­
will­do­the­job­better­and­safer­at­the­
rate for which it was designed.
b) Do not use the power tool if the
switch does not turn it on and
off.­Any­power­tool­that­cannot­be­
controlled with the switch is dangerous
and­must­be­repaired.­
c) Remove the plug from the wall
socket and/or remove the re-
chargeable battery before you
change the device's settings,
change accessory parts or put
away the power tool.­Such­pre-
ventive safety measures reduce the risk
of­starting­the­power­tool­accidentaIly.­
d) Store idle power tools out of the
reach of children and do not al-
low persons unfamiliar with the
power tool or these instructions
to operate the power tool. Power
tools are dangerous in the hands of
untrained users.
e) Look after the power tool and
application tool carefully. Check
for misalignment or binding
of moving parts, breakage of
parts and any other condition
that may affect the power tool's
operation. If damaged, have the
power tool repaired before use.
Many­accidents­are­caused­by­poorly­
maintained­power­tools.­
f) Keep cutting tools sharp and
clean. Properly­maintained­cutting­
GB IE
21