Reversing The Doors - Kuppersberg Rbn 1970 Technischer Pass

TECHNICAL PASSPORT
Integrated fridge freezer
Once complete, and if you are happy
with the fit of the appliance in the cabi-
net, bend and snap the parts of the white
spacers marked «S» as shown by the dot-
ted outline in Fig. 9. Leave the rest of
the spacer cover in place over the metal
plates.
Fig. 9
Important: After completing the
installation, check that the appliance
is secured within the unit and that the
door(s) close and open properly. If there
is no resistance from the door seals when
opening the doors, then it is probable
that the appliance and/or decor doors are
not fitted properly.
34
another individual to support the doors
whilst performing this operation.
for the top hinge and unscrew the screws
fixing the top hinge to the appliance, you
should support the upper door whilst do-
ing this.
and place it somewhere safe. Note that
there are spacers between the door and
S
the hinge, note how many and their posi-
tion.
moving the 3 screws fixing it to the ap-
pliance, support the lower door whilst
doing this.
it somewhere safe, again noting the posi-
tion of any spacer pieces.
the opposite side at the bottom.
spacers and position the central hinge on
the door. After removing the 3 cover caps,
fix the hinge securely to the appliance.
to the opposite side at the top. Refit the
upper door and the hinge fixing securely
to the appliance.
hinge cover pieces in place to complete
the process.
from the doors and swap them over to
the side furthest from the new hinge po-
sitions, before the decor door is fitted.

REVERSING THE DOORS

We recommend you seek the help of
 Carefully prise off the cover cap
 Carefully remove the upper door
 Remove the central hinge by re-
 Remove the lower door and place
 Swap the previous top hinge to
 Refit the lower door using any
 Swap the previous bottom hinge
 Fit the central cover caps and top
 Unscrew all four slider brackets
ENGLISH