Care And Cleaning; Troubleshooting - Kuppersberg Rbn 1970 Technischer Pass

TECHNICAL PASSPORT
Integrated fridge freezer

CARE AND CLEANING

Always disconnect the appliance from
the power supply before any cleaning or
maintenance.
The fridge and freezer sections should
be cleaned using a solution of bicarbon-
ate of soda and lukewarm water. Do not
use abrasive products or detergents. After
washing, rinse and dry thoroughly.
Clean the shelves and balconies sep-
arately by hand with a mild solution of
washing up liquid and water. Do not put
them in the dishwasher.
If the appliance is not to be used for
prolonged periods of time, unplug and
clean the appliance. The doors should be
left slightly ajar to prevent the formation
of mildew and unpleasant odours.
28

TROUBLESHOOTING

If you have any problems with your
appliance, you should check the trouble-
shooting prior to calling Customer Care.
If the appliance is not working, check:
 That there is power to the appli-
ance.
 The house fuses are intact and the
fuse in the plug has not blown.
 The fridge has not been turned off.
 The plug socket is functioning
fine. To check this, plug another electrical
appliance in to see if the socket is faulty.
If the appliance is working, but not
very well, check:
 The appliance is not overloaded.
 The thermostat is set to an appro-
priate temperature.
 The doors are closing properly.
 The cooling system at the rear of
the appliance is clean and free of dust,
and not touching the rear wall.
 There is enough ventilation at the
side and rear walls.
If the appliance is noisy, check:
 The appliance is level and stable.
 The side and rear walls are clear,
and there is nothing resting on the ap-
pliance.
Note: The cooling gas in the re-
frigerator may make a slight bubbling or
gurgling noise, even when the compres-
sor is not running.
If the appliance is beeping, check:
 That the doors are closed. An
alarm will sound after 60 seconds of a
door being open.
ENGLISH