Kuppersberg RBN 1970 Technischer Pass Seite 33

ENGLISH
MOUNTING THE FASCIA DOORS
 Ensure that there is a gap of 3 to
4mm between the non-hinged side and
the cabinet wall.
 Locate the slider in the bracket
and fix the slider to the fascia door 20
to 22mm from the edge of the fascia as
shown in Fig. 6, ensuring that the slider
is positioned centrally and horizontally
within the bracket. Tighten securely by
hand.
20 mm
Gasket
x4
Fig. 6
Fig. 7
TECHNICAL PASSPORT
Integrated fridge freezer
 Fill the gap on the non-hinged side
with the gasket/seal strip provided, as
shown in Fig. 7.
 The finished look for the door slid-
ers should be similar to those shown in
Fig. 8, which shows 2 sliders in place.
 Ensure the appliance doors open,
close and seal properly.
Fig. 8
Decor door
33