MPM MOD-48 Bedienungsanleitung Seite 46

EN
CLEANING THE FILTER
1. Check the cleaning filter periodically to maintain its
performance.
2. If the dust being sucked is very fine, the HEPA filter
may need to be cleaned more often.
3. Wash the sponge of the water filter using warm wa-
ter without any detergent (Fig.1, Fig.2)
4. Cleaned and dried filters should be stored in a dry
place for at least 24 hours before being able to use
again.
Do not put the filter in the dishwasher, wash-
ing machine, tumble dryer, oven, microwave
oven or open fire (Fig. 3).
SUPPORT FOR ACCESSORIES
STORAGE OF ACCESSORIES
- store aluminium pipes and ends in the container foot
REPLACE THE BATTERY IN THE REMOTE CONTROL MODULE
1. The battery lid can be opened by pressing the fastening on the front of the battery compartment
with a screwdriver (Fig. 1).
2. Remove the old batteries from the remote control module (Fig. 2).
3. Replace with a new 23A 12V alkaline battery, paying attention to the proper placement of anode
and cathode during mounting (Fig. 3).
4. mount the remote control lid (Fig. 4).
CAUTION! The remote control module can only be used with a 23A 12V alkaline battery. Do not
use batteries with different parameters to avoid damaging the module.
46