MPM MOD-48 Bedienungsanleitung Seite 44

EN
CLEANING CARPETS
1. Ensure the power cord is disconnected from the power source (Fig. 1).
2. Put the sponge of the water filter on the protruding element from the top lid , making sure that it
covers the entire element (Fig. 2 and Photo.1).
3. Place the top lid on the container and lock using with clamps situated on both sides (Fig. 3).
4. Insert the end of the suction hose and the small tube attached to the hose into the appropriate
holes in the container and tighten them clockwise (Fig. 4).
5. Remove the washing liquid container from the foot, unscrew the lid counterclockwise and fill it
with clean water mixed with washing liquid in proportions provided by the liquid manufacturer
(Fig. 5).
6. Insert one end of the tube into the container inlet connection; Place the other end of the inlet pipe
with the filter in the washing liquid container, then tighten the pipe clockwise (Fig. 6).
7. Insert the aluminium water spray pipe into the remote control handle, and then insert the water
inlet pipe into the water inlet connector on the remote control handle (Fig. 7).
8. If necessary, mount two connected aluminium water spray pipes in order to increase the radius
(Fig. 8)
9. Connect the large washing nozzle to the aluminium tube, insert the spray tube into the appropriate
inlet (Fig. 9).
10. Plug in the power cable (Fig. 10).
11. Press the power switch, the indicator on the panel lights up (Fig. 11).
12. Press the spray switch on the container or on the remote control module; the large washing tip will
start spraying water. After pressing the suction operation switch, the device will spray clean water
44