MPM MOD-48 Bedienungsanleitung Seite 41

DRY VACUUMING
1. Ensure the power cord is disconnected from the power socket (Fig. 1).
2. Loosen the container clamps (Fig. 2).
3. Lift the top lid off the container (Fig. 3).
4. mount the HEPA filter by pressing the top lid filter firmly (Fig. 4) and put the paper bag on the inner
air inlet (Photo 3)
5. Place the top lid on the container and lock it using the container clamps on both sides of the vac-
uum cleaner (Fig. 5).
6. Mount the suction hose with the spray pipe into the appropriate air inlets (insert them and tighten
them clockwise (Fig. 6).
7. Connect the aluminium pipe containing the suction hose with the handle, the remote control mod-
ule and the spray pipe, using all appropriate holes in the handle (Fig. 7).
8. If necessary, select two connected aluminium tubes in order to increase the operating radius
(Fig. 8)
9. Connect the water and dust collecting tip to the aluminium pipe (Fig. 9).
10. Plug in the power cable (Fig. 10).
11. Press the power switch, the indicator on the panel lights up (Fig. 11).
12. Press the suction operation switch on the main panel or remote control handle to make the device
start working. The suction mode works in two ways: high and low; when working in high mode,
press the suction operation switch and vacuuming switching to low mode, press the button again
and the suction will stop working (Fig. 12).
EN
41