MPM MOD-48 Bedienungsanleitung Seite 43

VACUUMING (COLLECTING) LIQUIDS
1. Ensure the power cord is disconnected from the power source (Fig. 1).
2. Put on the water filter sponge, making sure that it covers the entire surface of the protruding part
from the top lid (Fig. 2).
3. Place the top lid on the container and lock using with clamps situated on both sides (Fig. 3).
4. Mount the selected accessories on the aluminium tube (Fig. 4).
5. Plug in the power cable (Fig. 5).
6. Press the power switch, the indicator on the panel lights up (Fig. 6).
7. press the suction mode button on the main panel or remote control handle; the device will start
working. the suction mode is divided into two levels: high and low; when working in high mode,
press the vacuum mode button to switch to low mode. By pressing it again, the vacuum cleaner
will stop working (Fig. 6-7).
8. When the water absorbed reaches maximum capacity, the safety valve will trigger and the dust
and water collecting tip, along with the aluminium pipe, will stop sucking liquids (Fig. 8).
9. Turn off the power and disconnect the power cord from the socket (Fig. 9).
10. Draining dirty water (Fig. 10).
11. To ensure the best wet vacuuming performance, remove the water filter sponge after its use
(Fig. 11).
12. After each use of wet vacuuming mode, the sponge should be washed with water and dried prior
to next use (Fig. 12).
EN
43