Assembling And Disassembling - Braun KM 3050 Handbuch

Using the Liquidiser goblet
Use the liquidiser goblet for mixing, chop-
ping and cutting small quantities.
Maximum capacity: 1l liquid (for milk-shakes
750 ml).
For speed applications see table VII.
17 Lid
18 Blade
19 Liquidiser jug
a Screw fastening
b Plastic ring
c Chopper/mixer bowl
d Seal
e Drive shaft with bottom
Larger quantities should preferably be pro-
cessed in the food processor bowl (11) with
the universal blade.
Important: The maximum processing time in
the liquidiser goblet is 1 minute. (Liquids may
be processed longer).
Place all ingredients into the liquidiser goblet
after having inserted the blade.
Liquids can only be added through the hole
in the lid if the motor is running. After use,
always remove the blade from the jug before
removing the processed food.
Blending of soups, milk-shakes, baby
food etc.
Speed 1–15 approx. 1 min
Cut the fruits for milk-shakes into smaller
pieces and process it before adding liquid.
Maximum capacity: 750 ml liquid, otherwise it
could froth over.
Hot foods can also be blended in this heat-
resistant jug. Baby food remains warmer if
the liquidiser goblet is warmed with hot water
beforehand.
Chopping
Speed 1–15 auto-pulse
Processing examples:
Parsley, garlic, onions or nuts can be
chopped, as well as hard bread rolls for
bread-crumbing and meat.
Do not chop: chocolate, parmigiano cheese,
ice, hard spices or coff ee.
Assembling and
Disassembling
Lid
For cleaning, remove the seal from the inside
of the lid (H). Please replace the dry seal
so that the plastic clips in the lid fi t into the
groove of the seal (19d).
Blade
To insert the blade into the jug, press it onto
the drive shaft until it clicks (I).
Remove the blade from the jug by taking hold
of the knob and, while pressing down with
your thumb, pulling it off the drive shaft (19e).
Liquidiser goblet
Remove the blade as described above. To
disassemble the jug (J), fi rst turn it upside
down, reach into it with one hand and hold the
plastic base of the drive shaft.
Then, using the pusher, unscrew the fastening
of the bottom by turning anti-clockwise.
Take off the screw fastening (19a), the plastic
ring (19b) and the jug (19c) one after the
5722010084_KM3050.indd 11 5722010084_KM3050.indd 11
other, so that fi nally, you only hold the drive
shaft (19e) with bottom and seal (19d) in your
hand.
To re-assemble, please proceed in the reverse
order (K): Place the seal onto the lower side of
the drive shaft bottom.
Turn the jug upside down and place the
opening in the jug bottom over the seal on the
drive shaft bottom. Please, be careful not to
dislocate the seal.
Place the plastic ring (19b) onto the jug
bottom so that the projection on the plastic
ring engages with the groove in the bottom
of the jug (next to handle). Fasten all of these
parts by turning the screw fastening (19a)
clockwise by means of the pusher.
Care and cleaning instruc-
tions for the stainless steel
mixing bowl
• Rinse in hot soapy water before fi rst use.
• Rinse in hot soapy water as soon as pos-
sible after use, especially after processing
very salty food.
• Stubborn food residues should be soaked
and removed with a sponge (do not use a
scouring pad) or brush.
• When cleaning in a dishwasher, remove the
stainless steel bowl from the dishwasher
as soon as the cleaning program is fi nished
in order to prevent stains from remaining
water drops. Be careful to avoid an over-
dose of cleaner and decalcifi er.
• Carefully dry the bowl before storing it
away.
Cleaning
Always switch off the motor fi rst and then
unplug the appliance before cleaning.
Clean the motor block (1) with a damp cloth
only.
Some types of food (e.g., carrots) can lead to
discolouration; wipe off fi rst with cooking oil
before washing.
The kneading attachment (6) and the drive
arm (7) should only be cleaned manually.
Do not immerse in water. All other parts can
be washed in the dishwasher at a maximum
temperature of 65 °C.
Parts which are diffi cult to reach, e.g., the
indentation on the inside of the lid should be
well cleaned with the spatula (8) and a brush
if necessary.
Do not use sharp objects for cleaning.
Subject to change without notice.
Please do not dispose of the product in
the household waste at the end of its
useful life. Disposal can take place at
Braun Service Centre or at appropriate
collection points provided in your country.
11
18.06.14 13:28 18.06.14 13:28