LEMKEN FixPack Betriebsanleitung Seite 26

6 TRANSPORT ON PUBLIC ROADS
6.1 Transport in half-turned position with Uni-wheel
Lock the locking pin of turnover mechanism.
−
Convert Uni-wheel to transport position.
−
Turn plough frame into half-turned position.
−
Lower plough and detach the top link from the plough.
−
See also instruction book of the plough.
−
The FixPack is positioned above the plough and can be transported without any
conversion work. The allowed transport height for driving on public roads must
be adhered to and may not be exceeded.
6.2 Transport in working position
Turn the roller (9) by 90° and lock it in this
position.
Unlock the locking pin (14) of the adjusting
device (6) and swing in the arm (4)
Pay attention to the roller so that it will not
touch the plough bodies
The general traffic rules have to be ad-
hered too!
If the roller projects the tractor laterally too
much, the roller must be brought into the fully swung-in positon.
Therefore the plough will be turned in left handed working position, the roller
turned by 90° and locked, the axle (20) locked and the plough turned in right
handed working position. After that swing-in the arm (4) as wide as possible to
the plough and lock it. Check whether the locking pins (14) and (21) are engaged
correctly.
• Never unlock pin (21), if the roller (9) is positioned in „swung-in"
position!
• Pay attention to sufficient manoeuvrability of the tractor!
• When driving on public roads with lifted implement the operation
lever must be locked against lowering!
24