Manitou MRT-X 2470 Privilege Plus ST3A S1 Betriebsanleitung Seite 298

EN
Configure the PFB fork carriage and couple it to the rotating telehandler
Position the rotating telehandler with PFB fork carriage coupled in a safe place, with ample cle-
arance and clear of obstacles of any sort.
- Remove the forks from the fork carriage:
• lower the telescopic arm holding the forks just lifted off the ground,
• using a 19 mm hexagonal key (1,
tioned in the middle of the upper guide of the fork carriage,
• move the first fork (3,

(4, 6) under the lower guide (5,

(6, 6) from the lower guide (5,

5), undo the bolts (2,

6) towards the middle of the fork carriage aligning it with the gap

6) of the fork carriage, then lift the tip to release it

6) on the fork carriage and move it outwards (7,

5) for locking the forks posi-

6).
26
1
2
5
3
5
4
7
6
6