Scheppach RS 350 Original Bedienungsanleitung Seite 26

• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards)
- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault
Motor does not run
Motor running but screen
drum does not turn
Screening material is not fully
screened
26 | GB
Possible cause
Connection cable defective
Switch defective
Motor belt defective or tension too low
Screen drum belt defective or tension
too low
Screening material clumping and/or too
moist
Screen drum angle too steep
www.scheppach.com
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for
this.
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal of
waste electrical and electronic equipment.
Remedy
Check the connection cable and
replace it, if required.
Arrange for inspection and repair of
the device by a specialist
Check the motor belt, tighten or
replace it.
Check the sieve drum belt, tighten
or replace it.
Break up the sievings and/or wait
for them to be drier.
Reduce the angle of the screen
drum