Scheppach RS 350 Original Bedienungsanleitung Seite 25

3. Secure the sieve drum in the transport position
with the safety splint, by doing the splint put into
the bore of angle sheet and drum frame.
4. Now you can transport the device easily and store
it without much space requirement. Make sure the
storage area is dry.
15. Maintenance
Attention!
Disconnect the mains plug before carrying out any
maintenance work.
Conduct maintenance and cleaning works only with
the unit shut off and the power supply plug pulled.
Adjusting the brush bar
If required, adjust the brush bar on the roller sieve. To
do this, loosen the three screws and push the brush
bar into the required position. Then hand-tighten the
three screws again.
Belt tension drive belt (Fig. 8)
After a period of use, the drive belt can extend or suf-
fer from wear and tear. This will prevent reliable power
transmission from the motor to the sieve drum. You
have to re-tighten the drive belt or replace it.
1. Unscrew the motor belt cover (Fig. 1-7).
2. Adjust the flat belt tension by loosening the three
motor screws (A) and push the motor upwards.
3. If you cannot tighten the drive belt, or/and it is po-
rous, it is worn and you have to replace it.
4. Hold the motor with one hand and hand-tighten
the motor screws (A) with the other hand.
5. Tighten the motor belt cover again.
Belt tension drum, Fig. 9
After a period of use, the drum belt (Fig. 1-11) can
extend or suffer from wear and tear. This will prevent
reliable power transmission from the drive wheel to
the sieve drum. You have to re-tighten the drive belt
or replace it.
1. Unscrew the drum belt cover (Fig. 1-12).
2. Loosen the bearing screws (A) and adjust the
bearing accordingly.
3. If the belt cannot be tightened, and/or it is porous,
it is worn and you have to replace it.
4. Hand-tighten the bearing screws again afterwards
and re-attach the drum belt cover to the casing.
WARNING!
Do not store the device without protection outside
or in a damp environment.
Connections and repair work
Connections and repair work on the electrical equip-
ment may only be carried out by electricians.
Please provide the following information in the event
of any enquiries:
• Type of current for the motor
• Machine data - type plate
• Engine data - type plate
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Spare parts*: Driving and driven belts, sieve inserts,
drum bars, collecting mat
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
16. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act [ElektroG]
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are not
installed permanently in the old appliance must be
removed non-destructively before disposal. Their
disposal is regulated by the battery law.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.
GB | 25