Emerson CSI 6500 Bedienungsanleitung Seite 21

Product Information / Produktinformation A6630
Sensor Connections & Mounting
Monitor system voltage
The monitor system voltages, required for the internal supply, are permanently checked on low
voltage. At recognition of under voltage, an error message will be generated and displayed via
status LED of the front plate.
1.7.7 Environmental conditions
Environmental temperature
Reference temperature
Nominal use range
Temperature f. storage and transport −20...+85 °C
Operating altitude
Relative humidity
Vibration
Amplitude
Acceleration
Shock
System of protection
EMC
Allowed degree of pollution
Environmental Area
1.7.8 Mechanical design
Printed board
Width
Height
Connector
Front elements
2 green LEDs
6 yellow LEDs
1 Mini−DIN circular connector
Weight
+25 °C
0...+45°C (CSA
requirement and recommended range
max. range 0°C ... +65°C (not CSA conform)
up to 2000m above sea level
≤ 95 % non−condensing
according to IEC−68 − 2 part 6
0,15 mm at 10...55 Hz
2
19,6 mm/s at 55...150 Hz
according to IEC−68 − 2 part 29 peak value
acceleration 98 m/s2 nominal shock
duration 16 ms
IP 00, open construction
according to EN 61326−1, Class A
Category 2 (According to IEC 61010−1)
Indoor use only
Euro−format (100 mm x 160 mm)
6 HP (approx. 30 mm)
3 RU (approx. 128 mm)
Type F 48 M, DIN 41 612
Left LED supply power Ok
Right LED module Ok
Outputs 1 ... 6
RS232 front socket to connect a laptop (for
configuration purposes)
approx. 200 g (without packing)
approx. 330 g (with standard packing)
Page 21
)