Zero Point Offset Load - Sony LY51 Bedienungsanleitung

7-2-4.

Zero point offset load

This starts the counting from the set value at the point when the zero point is passed. The maximum, minimum and peak-to-
peak values restart from the set value.
When the zero point is loaded during the zero point reference mode, the zero point reference mode is canceled.
(Continued from 7-2-1.) (P.171)
1. Select "OFL" and press
ENTER
The unit is placed in the zero point load wait status.
The REF LED flashes.
You can interrupt the operation by moving the cursor to
"End" and pressing
ENTER
2. Input the offset value.
Press to change the number.
Press to change the digit.
3. Set the required offset value and press
4. (Zero point passed)
The REF LED goes off and counting starts.
.
.
.
ENTER
Main display
Sub-display
Main display
Sub-display
173