Sony LY51 Bedienungsanleitung Seite 128

3 Display data setting
This sets the data to be displayed on the main and sub-displays. The current value or the peak value (maximum, minimum and
peak-to-peak values) can be displayed on the main display. If the peak value is selected for the main display, the display can be
switched with the current value by pressing MODE/ENTER key. (The current value is the value selected in item 2 above.) The
current value, peak value or the judgment results when a comparator unit is connected can be displayed on the sub-display. If
the number of connected scale axes is set to "1" in item 2 above, the display goes blank when the unconnected axis is
selected as the display data. For example, if 1st axis only is selected in item 2 above, the respective display goes blank when
the 2nd axis is selected.
For individual input:
Main display:
Addition/subtraction
axis*
Sub-display (left):
Minimum value
Sub-display (right):
Maximum value
For AUTO input:
• • 3 5 4 • • • • • • • • • •
* When 1st and 2nd axes independent is selected for the addition/subtraction axis, the 1st axis is used.
126
(2) What is to be
Number of
displayed on
connected
the main
scale axes?
display?
(1)
(1st axis, 2nd axis,
peak value)
What is to be What is to be
displayed on displayed on
the sub- the sub-
display? display?
(Minimum and maximum values)
(Peak value for a combination
other than 1st and 2nd axes or
minimum and maximum
values, or blank display)
(Minimum and
(Addition/
maximum
What is to be
subtraction
values)
displayed on
axis*)
the sub-
display?
(Peak value for a combination
other than 1st and 2nd axes
or minimum and maximum
values)
(Minimum and maximum values)
(Other than minimum and
maximum values)
Setting unnecessary
(Initial value)
"dSP" and subordinate menu sub-
display settings are necessary.
(For AUTO input, set the numbers
in the fourth and fifth digits.)
"dSP" and subordinate menu
main display settings are
necessary. (For AUTO input, set
the number in the third digit.)
"dSP" and subordinate menu
setting is necessary. (For AUTO
input, set the numbers in the
third to fifth digits.)