Connecting Additional Helmet Sensors; Installing The Motorcycle Unit - Schuberth Riderecall Bedienungsanleitung

C. SChuberth ridereCall

6. connecting additional Helmet sensors

You can connect additional helmet sensors to your motorcycle
unit if you have more than one helmet or if you are travelling
with a passenger.
1. Download the RiderEcall software from the SCHUBERTH
website: www.schuberth.com
2. Install the RiderEcall application on your computer. (Follow
the installation instructions)
3. Connect the motorcycle unit with the USB port of your
computer. (The USB cable is included in the package.)
4. Click on "User" to connect the motorcycle unit with your
computer.
5. Now select the Edit tab.
6. Enter the serial number of the second or third helmet sensor
and confirm your entry by pressing "Learn".
7. Your helmet sensor is now connected with the motorcycle
unit.
You can view the complete description of the software on our
web site: www.schuberth.com
30

7. installing tHe motorcycle unit

Use the mounting supplied to install the motorcycle unit. This
ensures permanent contact between the unit and GPS satellites
and thus the GSM network, where continuous network coverage
is available.
• Remove the two self-locking nuts
from the bottom part of the mount.
For this you will need a 10 mm
wrench.
• Use the clip to fix the mount to your
chosen position on your motorcycle
and then tighten up the nuts. We
recommend that you fit the unit to
the handlebar.