Fitting The Helmet Sensor - Schuberth Riderecall Bedienungsanleitung

C. SChuberth ridereCall
Activation of the unit may take up to 36 hours. Only after this
is it fully ready for use. You can check the functioning status of
the unit at any time from the status LEDs. For information about
setting the unit up and operating status, see section 10.
Note: SCHUBERTH takes personal data protection very
seriously. You can view and download our data protection
policy here:
http://www.schuberth.com/en/disclaimer-data-protection.
html
4.1 Emergency medical record
When you register your system, you have the possibility of
creating an individual emergency medical record with our
service partner, the Björn Steiger Foundation. In the event of an
emergency the relevant information from the record can then be
passed to the rescue centre along with an emergency call, thus
providing the rescue personnel on the ground with important
information.
To set up an emergency medical record, please visit:
http://www.steiger-stiftung.de/Notfallakte
Note: SCHUBERTH recommends that you set up a full
emergency medical record. The information you provide
could help to save your life in an emergency.
28

5. Fitting tHe Helmet sensor

The helmet sensor comprises two parts:
• Helmet sensor
• Rubber housing for mounting to the helmet and providing
protection from weather and vibration
The helmet sensor is delivered pre-assembled to make it easier
for you to attach.
1. Clean the mounting area on the helmet. The mounting area
must be free of any grease or other impurities.
2. Pull the tab on the underside of
the sensor to activate the battery.