Werbung
Verfügbare Sprachen
Verfügbare Sprachen
activated. The digital charging
display
indicates that a car is
3
connected:
The left part of the LED strip
flashes.
The charge current can be
selected again by pressing the
button
within 5 seconds.
4
However if you want to discon-
nect the mobile charging station
from your car, proceed as
1
follows:
Finish the charging process on
„
the car.
Unplug the plug
„
Error messages:
Fault
Meaning
ERROR 1
The temperature
is too high.
(the temperature
in the housing has
increased to over
70 °C)
ERROR 2
Charge current
is too high
(the charge current
is 2 A higher than
the set value)
ERROR 3
Residual current
(residual current is
greater than 6 mA
DC or 30 mA)
2
from the car
9
and put the cover cap
plug
.
9
Then unplug the mains plug
„
from the 230 V socket.
Re-wind the charging cable
„
properly afterwards and when
doing this, making sure that the
cable is not kinked.
Now store the mobile charging
„
station
1
ing and keep it in the car.
Voltage failure:
If there is a voltage failure, the
charging process will automatically
resume once the voltage returns.
Solution
Disconnect from the car and mains.
Wait until the housing temperature
has dropped, then start the charging
process again.
Disconnect from the car and mains.
Then start the charging process again.
Disconnect from the car and mains.
Then start the charging process again.
GB/IE/NI/CY/MT
on the
8
properly in the packag-
7
15
Werbung
