Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The left part of the LED strip
flashes and indicates that
charging is not taking place.
Remove the protective cap
„
from the plug
Plug the plug
„
The digital charging display
indicates that a car is connected:
The left part of the LED strip
continues to flash.
Start the charging process on
„
the car, if you want to charge
immediately, without using the
car's timer.
Selecting the charge current:
„
each time you press the button
a different charge current will
4
be displayed (charge current
on the display
charge currents can be selected:
6 A (approx. 1.4 kW at 230 V)
8 A (approx. 1.8 kW at 230 V)
10 A (approx. 2.3 kW at 230 V)
13 A (approx. 3.0 kW at 230 V)
16 A (approx. 3.7 kW at 230 V)
If the button
5 seconds, the selection is con-
firmed. The last selected charge
current will always be stored.
The charging process will now
„
8
on the car side.
9
into the car.
9
). The following
3
is not pressed for
4
be activated as long as the car's
charging timer is deactivated.
The digital charging display
indicates that the car is being
charged:
2
The LED strip
up from left to right and this
3
indicates that current is flowing
into the car.
Otherwise the charging process
will start at the time programmed
in the car. In this case, the digital
2
charging display
a car is connected:
The left part of the LED strip
continues to flash.
10
Some cars carry out a test charge
first for a few seconds. In this
case the digital charging display
indicates that the mobile
3
charging station is ready to
charge at the time programmed
in the car:
Other cars take a very low
continually lights
2
indicates that
3
GB/IE/NI/CY/MT
3
2
13
Werbung
