Scheppach WSE1100 Original Bedienungsanleitung Seite 27

The welding cables should be kept as short as pos-
sible.
Warning! This power tool generates an electromag-
netic field during operation. This field can impair active
or passive medical implants under certain conditions.
In order to prevent the risk of serious or deadly injuries,
we recommend that persons with medical implants
consult with their physician and the manufacturer of
the medical implant prior to operating the power tool
6. Technical data
Mains connection
Welding current
On-load factor X
25%
60%
100%
Energy efficiency of the power
source
Idling voltage (V)
Idle state power consumption
Weight
Subject to technical changes!
7. Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material as well as the pack-
aging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, keep the packaging until the expiry of the
warranty period.
ATTENTION
The device and the packaging are not children's
toys! Do not let children play with plastic bags,
films or small parts! There is a danger of choking
or suffocating!
8. Attachment / Before starting the
Fitting the carrying strap (Fig. B)
Attach the carrying strap (11) as shown in Fig. B.
Installing the welding shield (Fig. C + D)
• Install the handle (14) on the welding shield (13) as
shown in Fig. D.
• Install the protective glass (15) on the welding shield
(13) as shown in Fig. D.
• Then fold the three sides of the welding shield. The
two sides each connect to the top with two press
studs.
230V~ 50/60Hz
20 - 160 A
Before starting the equipment
Connecting to the mains power supply
Before you connect the power cable (8) to the mains
160 A
power supply, make sure that the data on the rating
100 A
plate is the same as that for your mains supply.
80 A
Connect the machine to a properly installed protec-
tive contact socket, with at least 16A circuit breaker.
85%
Danger! The mains plug may only be replaced by a
qualified electrician.
85 V
18 W
Connecting the welding cable (Fig. E)
6.6 kg
Danger! Always make sure the device is unplugged
before carrying out any connection work on the weld-
ing cable (9+10)! Connect the welding cable as shown
in Fig. E.
To do so, connect the two connectors on the electrode
holder (9) and the ground terminal (10) to the corre-
sponding quick-lock couplings (6/7) and lock the con-
nectors in place by turning them in a clockwise direc-
tion.
The cable with the electrode holder (9) is normally con-
nected to the positive pole (6) and the cable with the
ground terminal (10) to the negative pole (7).
Welding preparations
Connect the earth terminal (10) direct to the part to be
welded or to the support on which the part is resting.
Ensure that the earth terminal is in direct contact with
the part to be welded. You should therefore avoid coat-
ed surfaces and/or insulated materials.
The electrode holder cable has a special clamp at one
end, which is used to secure the electrode.
www.scheppach.com
equipment
GB | 27