Scheppach WSE1100 Original Bedienungsanleitung Seite 19

Explanation of the symbols on the device
Symbols are used in this manual to draw your attention to potential hazards. The safety symbols and the
accompanying explanations must be fully understood. The warnings themselves will not rectify a hazard and cannot
replace proper accident prevention measures.
EN 60974-1
f
1~
1
f
2
U
0
U
1
X
l
2
U
2
Read the operating and safety instructions before start-up and follow them!
European standard for welding sets for manual arc welding with limited on time.
Single-phase static frequency converter transformer rectifier
Symbol for manual arc welding with sheathed rod electrodes
Direct current
Suitable for welding with increased electric risk
Power input; phase number, as well as
Alternating current symbol and rated value of the frequency
Rated idling voltage
Mains voltage
On-load factor
Welding current
Welding voltage [V]
www.scheppach.com GB | 19