Hitachi RAS-25QH1 Technische Information Seite 31

AUTOMATIC OPERATION
The device will automatically determine the mode of operation, HEAT, COOL, or
Dehumidify, depending on the initial room temperature. The selected mode of operation
will not change when the room temperature varies.
HITACHI
ae)
16)
[| _SO ms
Press the FUNCTION selector so that the display indicates
the © (AUTO) mode of operation.
e When AUTO has been selected, the device will
automatically determine the mode of operation, HEAT,
COOL, or Dehumidify, depending on the current room
temperature.
Press the © (START/STOP) button.
Operation starts with a beep.
Press the button again to stop operation.
@ As the settings are stored in memory in the remote controller, you only
have to press the © (START/STOP) button next time.
You can raise or lower, the temperature setting as necessary by a
maximum of 3°C.
Press and the temperature setting will changeby
1°C each time.
© The preset temperature and the actual room temperature may
vary somewhat depending on conditions.
® The display does not indicate the preset temperature in the AUTO
mode. !f you change the setting, the indoor unit will produce a
beep. :
Press the -& (FAN SPEED) button, AUTO and LOW is available.
= @ Condition of Automatic Operation
initial room temperature (approx.) Temperature setting
Over 27°C
23~27°C DEHUMIDIFY Slightly lower than the ron
temperature
- 29--