Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MODEL
RAS-25QH1, RAS-32QH1, RAS-40QH1
NAMES AND FUNCTIONS OF EACH PART
REMOTE CONTROLLER
This controls the operation of the indoor unit. The range of control is about 7 meters. If
indoor lighting is controlled electronically, the range of contro! may be shorter.
This unit can be fixed on a wall using the fixture provided. Before fixing it, make sure the
indoor unit can be controlled from the remote controller.
\____=
Signal emitting window/transmission sign
Point this window toward the indoor unit when controlling it.
The transmission sigh blinks when a signal is sent.
Display
This indicates the room temperature selected, current time, timer status,
function and intensity of circulation selected.
START/STOP button
.
Press this button to start operation. Press it again to stop operation.
SLEEP button
Use this button to set the sleep timer.
DEHUMIDIFY button
Dehumidify mode direct selection.
TEMPERATURE buttons
Use these buttons to raise or lower the temperature setting. (Keep pressed,
and the value will change more quickly.)
RESET buttons
TIME button
Use this button to set and check the time and date.
FUNCTION selector
Use this button to select the operating mode. Every time you press it, the
mode will change from © (AUTO) to © (HEAT) to © (DEHUMIDIFY) to #
(COOL) and to -* (FAN) cyclically.
FAN SPEED selector
This determines the fan speed. Every time you press this button, the intensity
of circulation will change from © (AUTO) to 7 (HI) to ¥ (MED) to 7 (LOW)
(during the -% (FAN) mode, from 7 HI to ¥ MED F LOW).
AUTO SWING button
Controls the angle of the horizontal air deflector.
TIMER control
Use these button to set the timer.
ON-TIMER button
Select the turn ON time.
OFF-TIMER button
Select the turn OFF time.
RESERVE button
Time setting reservation.
CANCEL button
Cancel time reservation.
Precautions for Use
Do not put the remote controller in the following places.
e In direct sunlight
e In the vicinity of a heater.
e Handle the remote controller carefully. Do not drop it on the floor, and
protect it from water.
© Once the outdoor unit stops, it will not restart for about 3 minutes
(unless you turn the power switch off and on or unplug the power cord
and plug it in again).
This is to protect the device and does not indicate a failure.
e If you press the FUNCTION selector button during operation, the
device may stop for about 3 minutes for protection.
SLEEPING
STOP (CANCEL)
START (RESERVE)
HI
MED
Low
START/STOP
TIME
TIMER SELECTOR
ON TIMER
OFF TIMER
AUTO SWING
| @ |
oO |
ra
FE FAN SPEED
0 |
pt
| O |
2 |
© |
@.
|
- 28 -
Werbung
