Yamaha FX500 Bedienungsanleitung Seite 8

4. The Controls: A Quick Operation Guide
@ Power Switch
Press once to turn the FX500 on, and a second time to
turn the power off. When the power is turned on, a title
and copyright notice will appear on the display panel for
a few seconds before operation actually begins.
@ Input Jack
Plug your guitar, keyboard or other signal source in
here or into the duplicate INPUT jack provided on the
rear panel (see "@INPUT Jack" in the "3. Connec-
tions: Basic System Setup" section). Both jacks are
standard monaural 1/4" phone jacks.
@ INPUT LEVEL Control with SIGNAL and PEAK
Indicators
For the optimum input level setting, play your source at
the highest level it will be played in actual use. Adjust
the INPUT LEVEL control so that the SIGNAL Indicator
lights most of the time but the PEAK indicator does not
light, or lights only occasionally on brief high-level
peaks.
ми
Y UN
S 42,
"е————— Should flash опју
SIGNAL (7 `
a E M or not at all.
/
Should fight most of the time
an input signal is present.
чо
INPUT LEVEL
© Liquid Crystal Display Panel
This is the FX500's main "information center", providing
all information necessary for effect program selection,
programming and utility control. і
Program number. |
9 l Broad Dist.
BYPASS Flg > Dly
Appears when BYPASS
key is pressed to bypass
all effects.
Currently setected effect, parameters
E being programmed, or utility function.
© COMP, DIST, EQ, MOD and REV Effect Keys
These keys function differently in the MEMORY and
PARAM modes.
• When the MEMORY mode is selected (i.e. when the
MEMORY key indicator is lit — see "@ MEMORY
Mode Key"), these keys are used to turn the
corresponding effect stage ON (indicator lit) or OFF
(indicator out).
[See page 10 for further details]
• When the PARAM mode is selected (i.e. when the
РАВАМ key indicator is lit — see "(PARAM Mode
Key"), these keys select the various parameters
available for editing in the corresponding effect
stage.
[See page 11 for further details]
Q Arrow ( Aand V) keys
The A and V keys function differently in the MEMORY,
PARAM and UTILITY modes.
* When the MEMORY mode is selected (i.e. when the
MEMORY key indicator is lit — see " MEMORY
Mode Key"), the A and V keys are used to select
the desired effect program.
[See page 9 for further details]
When the PARAM mode is selected (i.e. when the
PARAM key indicator is lit — see "PARAM Mode
Key"), they are used to "edit" the selected effect
parameter.
[See page 11 for further details]
* When the UTILITY mode is selected (i.e. when the
UTILITY key indicator is lit — see "(UTILITY Mode
Key"), the A and V keys are used to program the
selected utility function.
[See page 19 for further details]