Yamaha FX500 Bedienungsanleitung Seite 22

21
In order to use this kind of setup, the two "controllers" that
the FX500 allows — CONTROLLER 1 and CONTROLLER
2 — must be set to receive specific MIDI CONTROL
. CHANGE data (i.e. receive data from a specific MIDI
controller) using the Control Change 1 Table Edit and
Control Change 2 Table Edit functions described below.
€ Control Change 1 Table Edit
When this function is called the LCD appears as shown
below, and the А and V keys can be used to select the
desired MIDI control change number for controller 1.
ТАМАНА = >< SOO
ШЇЇ
85 CONTROLLER 1
1 MOD. WHEEL
UN
85 CONTROLLER 1
1 MOD. WHEEL
The following control change numbers and associated
controllers (or none of no controller is specifically
assigned) can be selected:
Control
Change Controller
Number Assignment
OFF Controller OFF
0 No specific controller assigned.
1 MOD. WHEEL
2 .BREATH CTRL
3 No specific controller assigned.
4 FOOT CTRL
5 PORT TIME
6 DATA ENTRY
7 MAIN VOLUME
8— 31 No specific controller assigned.
64 SUST SWITCH
65 PORT SWITCH
66 SUST PEDAL
67 SOFT PEDAL
68— 95 No specific controller assigned.
102 — 114 No specific controller assigned.
* Press the STORE key to directly assign "OFF".
If NOTE ON VELCTY is assigned and a number.of NOTE
ON messages are received simultaneously (e.g. a chord is
played), the NOTE message with the highest note number
takes priority.
NOTE: The FX500 only receives control change data on
the MIDI channel specified using the MIDI Setup
function.
€ Control Change 2 Table Edit
This function operates in exactly the same way as Control
Change 1 Table Edit, above. The LCD appears as shown
below, and the Á and V keys can be used to select the
desired MIDI control change number for controller 2.
B5 CONTROLLER 2
2 BREATH CTRL
NOTE: The contro! number assigned to controller 1, also
can be assigned to controller 2.
€ Assigning CONTROLLER 1 and CONTROLLER
2 to Specific Effects
ҮАМАНАР= >< SOO
QUAENAM
85 CTRL1 MIN-MAX
VOLUME 0 100
Осоыг Oost Oto
СО CO|CO C
ГОРЕ ов eg Qumny
III | A Soles
Once the MIDI controllers you wish to use have been
selected using the Control Change 1 Table Edit and
Control Change 2 Table Edit functions described above,
you can then assign the controllers to the specific FX500
effect parameters. Control assignment is carried out in the
PARAM mode.
(D First select the appropriate effect in the MEMORY
mode, then activate the parameter mode by pressing
the PARAM key (of course, this step is not necessary if
you're already editing an effect in the parameter mode).
(Q) To assign CONTROLLER 1 to an effect parameter,
press the SEL/ASN key in the parameter mode and a
display similar to the following will appear.
CTRL1 MIN-MAX
85 VOLUME 0100