Herunterladen Diese Seite drucken

EuroLite ZEITGEIST TMH-360Z INFINITY Bedienungsanleitung Seite 36

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
The device is equipped with a lockable power input connector. Plug in the power cord and turn it to the right
until it locks. Plug the power cord into a grounded electrical outlet that matches the rated voltage of the
machine.
Connection between devices
On the rear panel, there is a socket (Power Out). Connect the output with the mains input of the next fixture
until all fixtures are connected.
Please note: A maximum of 8 EUROLITE Zeitgeist TMH-360Z INFINITY may be linked together. After
every 8 devices, the fixtures must have a renewed connection with the power mains.
OPERATION
With the power switch, you can switch the device on and off.
After you connected the spot to the mains, the EUROLITE Zeitgeist TMH-360Z INFINITY starts running.
During the reset, the motors are trimmed and the device is ready for use afterwards.
The device has two operating modes. It can be operated in stand-alone mode via LCD display with operating
buttons or in DMX-controlled mode via a lighting controller.
Stand-alone Mode
In the stand-alone mode, you can do without a controller. Disconnect the EUROLITE Zeitgeist TMH-360Z
INFINITY from the controller and call the internal program.
Please refer to the instructions under Control Board.
International
L
N
36/52
00083593.DOC, Version 1.0

Werbung

loading