Master/Slave-Operation; Connection With The Mains; Operation; Stand Alone-Mode - EuroLite LED Bar RGBA 24/1 Bedienungsanleitung

Master/Slave-Operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the EUROLITE LED Bar RGBA 24/1 you can find an XLR-jack and an XLR-plug, which
can be used for connecting several devices.
Choose the device which is to control the effects. Set the desired Master-mode on the master-device. This
device then works as master-device and controls all other slave-devices, which are to be connected to the
master-device via a balanced microphone lead. Set the DMX start address 001 on every slave-device and
the DMX mode on your master device. For example, if the master-device is set on the 6 channel mode (6ch),
all slave-devices have to be set on the 6 channel mode as well. Connect the OUT-jack with the IN-plug of the
next device.

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED BAR RGBA 24/1 starts running. The LC
display lights up and you can choose the desired mode via the MODE button:
The device has two operating modes. It can be operated in Stand Alone or in DMX-controlled mode.

- STAND ALONE-MODE

• Setting Solid Colors
• Internal Programs, Sound Control
• Setting Sound Sensitivity
- DMX MODE
STAND ALONE-MODE
In Stand Alone Mode, the LED BAR RGBA 24/1 can be used without a controller.
Disconnect the LED BAR RGBA 24/1 from the controller.

Control Board

The Control Board offers several features: you can run the internal programs or set the starting address.
Browse through the main menu by pressing MODE. You can change the selection by pressing UP or DOWN.
The functions provided are described in the following sections.
International
L
N
21/25 00048772.DOC, Version 1.0