Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Connection with the mains
Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.
On the rear panel, there is an IEC socket (Power Out). Connect the output with the mains input of the next
fixture until all fixtures are connected.
Please note: A maximum of 8 devices may be linked together. After every 8 devices, the fixtures must have
OPERATION
After you connected the spot to the mains, the device starts running.
The LED display lights up and you can choose the desired mode via the buttons MODE, SET UP, UP and
DOWN.
See following graphic.
International
L
N
a renewed connection with the power mains.
23/30
00064374.DOC, Version 1.0
Werbung
Inhaltsverzeichnis
