Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Screw the clamp/clamps via a M10 screw and self-locking nut onto the Omega-holder.
Insert the quick-lock fasteners of the Omega-holder into the respective holes on the
bottom of the device. Tighten the quick-lock fasteners fully clockwise.
On vertical trussing, please make sure that the Omega-holder and the clamp are
mounted perpendicularly to the truss, as shown on the drawing to the right. Use
only one clamp, centered on the Omega-holder, when installing the device
vertically.
DMX-512 connection/connection between fixtures
The wires must not come into contact with each other, otherwise
the devices will not work at all, or will not work properly.
Please note, the starting address depends upon which controller is being used.
Only use a DMX-cable and 3-pin XLR-plugs and connectors in order to connect the controller with the fixture
or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated. Plug the terminator with a 120
resistor
between Signal (–) and Signal (+) in the DMX-output of the last fixture.
Master/Slave operation
The master/slave operation enables that several devices can be synchronized and controlled by one master
device.
On the rear panel of the device you can find an XLR jack and an XLR plug, which can be used for
connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX-cable. Connect the OUT jack
with the IN plug of the next device.
Set the desired Master-mode for the master-device. Set the respective Slave-mode for all slave-devices.
Please refer to the instructions under Control Board.
35/52
00083593.DOC, Version 1.0
Werbung
