Werbung
Verfügbare Sprachen
Verfügbare Sprachen
MAINTENANCE
MAINTENANCE
5.1
Maintenance work schedule
- Oil level check in the hydraulic installation
- Oil change in the hydraulic installation
- In the first year of operation
- Oil filter level check
If required, change filter.
- Lubricate the mower knife drive gearbox
- Lubricate the mower knife head bearing -
- Lubricate the side cutter drive shaft
5.2
Maintenance work schedule
System
Oil grade
Hydraulic system
Multi-season oil
Shell – Hydren HV 46 Tellus – T 46
Donar – TM
Fuchs – Kreolin D 46 HV
Wintershall – HVG 46
Drive gearbox of the
Grease
horizontal mower knife
FINA - Marsen EPL 2
SHELL - Retina EP 2
SHELL - Alvina G3
FUCHS - Rendite TEP 2
ARAL – Aral üb HLP 2
5.3
Oil change
Remove the safety lock and open the protective hood (V) and (P) (Figure 39, Figure 40). Unscrew the flexible tube of the pump
connection. Collect the pouring gearbox oil in the corresponding container.
Dispose of the hydraulic oil in accordance with applicable regulations.
After complete emptying, screw the flexible tube in tight again. (Figure 42)
Figure 42
Unscrew the vent screw from the oil container and fill in the oil through the filler opening until the level has reached half of the
oil-level glass.(Figure 43
- Every 50 working hours.
DANGER!
Any repair, maintenance and cleaning work as well as troubleshooting may only be carried
out when the drive and the motor are switched off – remove the key from the ignition lock!
ENVIRONMENT!
- Every 50 working hours.
- once a year or every 500 hours.
- After the first 40 hours
- Every 100 hours
- Every 50 hours
Every 100 hours.
Quantity
3-4 litres depending on the
width of the grain header
25
Change interval
Check
According to the
According to
maintenance
the main-
work schedule
tenance work
schedule
According to the
main-tenance
work schedule
Werbung
