Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
3.3
Fitting the mower knife belt drive. Figure 22
Fit the belt drive with sprocket (from the CERIO gearing) instead of the bevel gearing removed Figure 22
Use the bolt from the gearing for this purpose.
Secure the header extension drive shaft to the supports on the belt set housing (Figure 23).
Fit the chain drive.
Figure 22
Figure 23
Secure the knuckle joint to the rear drive shaft
Fit the rear drive shaft protection on the left-hand side
3.4
Installing the holders ()
Drill two 11 mm holes in the centre of the frame according to the specified sizes
A = 160 mm
B = 35 mm
Figure 24
C = 50 mm
(rys.7)
18
Figure 25
Werbung
