Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Figure 30
!
Fitting the central support
Start the diesel-powered motor and lift the grain header with the attached rapeseed header extension.
Switch off the diesel-powered motor. Secure the hydraulic cylinder of the inclined conveyor by using the safety support as
described under Figure 27
Unscrew and disassemble the three screws "A" fastening the double fingers to the finger bar of the grain header that are
closest to the central support arm of the rapeseed header extension. Screw on the fingers again. In order to do so, use the
longer screws that were supplied with the rapeseed header extension.
Figure 31
plate "B" onto the screws and screw them in tight by using the supplied nuts.
Slide in plate "C" with its slots between plate "B" and the double fingers of the grain header.
PLEASE NOTE !
Tighten the nut on the clamping device so that the rapeseed header extension lies
tightly on the slide shoe of the header extension. (see arrow).
(Figure 27)
DANGER!
Figure 32
21
Werbung
