Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
Regulating the position of reel arm supports
Figure 36
Regulation: above-below, fore-rear, left-right Depending on requirements, if the reel arms do not meet the spacers for the
restriction of the minimum reel height, you can change the position of the spacers or turn them 180 degrees (Figure 36)
Fitting the drive belt
Figure 38
Tighten the mainspring using the nuts for blocking the gears and then turn through two full revolutions.
3.6
Preparing and carrying out the test operation
1.
Tighten all screws.
2.
Switch off equipment again.
3.
Install all safety devices in such a manner that they function properly.
4.
Check the electrical connections!
5.
Check the machine settings.
6.
Lubricate all necessary lubrication service points.
7.
Remove the side knife protective strips.
8.
Place several oil drops between the knife blades and the side knife and start them for a moment.
9.
Check the oil level.
10. Start the rapeseed header extension for approx. one minute and switch it off afterwards.
11. Refill the oil level in the rapeseed header extension oil container up to half of the oil-level glass.
12. Check the tension of the V-belt.
Figure 37
23
Werbung
