Werbung
Verfügbare Sprachen
Verfügbare Sprachen
USE / LIMITATIONS OF USE / SECURITY /
(Pic.1)
Low stretch ropes are NOT to be used for free
climbing, mountaineering or in caving (different
standards apply such as EN 892 "dynamic mountai-
neering ropes").
The system must include a reliable anchoring point
(in accordance with EN 795) above the user. The
low stretch kernmantel rope should not be allowed
to sag between the user and the reliable anchoring
point.
Type A and B ropes:
The performance requirements of Type B ropes are
lower than those for Type A ropes.
Accordingly, when using Type B ropes, grea-
ter care is required for protection against the
effects of friction, cuts, general wear and tear
etc. Consequently, the possibility of a fall must
be minimised by applying maximum caution.
Type A ropes are more suitable for rope-assisted
work or working place positioning than Type B
ropes.
LIMITATIONS OF USE
Do not carry out any rope-assisted work if your phy-
sical condition means that your safety could be at
risk during normal use or in an emergency.
Any changes or additions to ropes to EN 1891 are
forbidden and may only be made by the
manufacturer. The breaking load of ropes / ropes
with terminations is specified for tension applied in
the ropes' longitudinal direction. Therefore, never
subject end loops, for example, to transverse loads
(2 karabiners in one loop). Check which load in the
selected configuration acts on the rope and make
sure that you do not overload it. We recommend a
safety factor ≥ 7.
BEFORE USING, PLEASE NOTE
The rope must be inspected visually before use to
check completeness, usable condition and proper
operation. If the equipment has been affected by a
fall, it must be withdrawn from use immediately.
Even if you have only the slightest doubt, the pro-
duct must be withdrawn and may only be used
TRANSPORT, STORAGE & CLEANING
again once an expert has authorised the use in wri-
ting following an inspection.
Knots in the rope reduce the breaking load.
Do not use ropes whose previous usage history is
unknown to you.
The user must ensure that the recommendations for
use with other elements are complied with. All
other elements of the arrester system must be certi-
fied and correspond with the relevant standards for
PSA such as descender devices EN 341, positioning
systems EN 358 or fall arrest systems EN 363.
Adjustment devices on descender devices must be
adjusted to the diameter of the rope.
Metal components must not include any burrs or
sharp edges that might cause damage to the rope.
You put yourself at risk by combining equipment
parts that impair the safe operation of any part of
the equipment or of the assembled equipment.
Before use, a plan for rescue measures must be
prepared to take account of all possible emergenci-
es. Before and during use, you must consider how
the rescue measures can be
carried out safely and effectively.
TRANSPORT, STORAGE & CLEANING
Low stretch ropes are usually made of polyamide
fibres. The sheathing can also contain polyester
fibres. Consequently, they should not be exposed to
heat exceeding 100°C. If you notice reactions such
as discolouring or hardening, the product must be
withdrawn for safety reasons. The rope can shrink
by up to 7% if exposed to humidity.
Accordingly, the rope should always be protected
against dirt and placed in appropriate
packaging (rope bag) during transport.
Place the rope in the bag loosely and do not roll it
up so as to avoid twisting.
Storage conditions:
dry and clean
at room temperature (15 – 25°C),
protected against the light (UV radiation, welding
equipment, ...),
away from chemicals (liquids, vapours,
gases, ...) and other aggressive conditions,
protected against sharp-edged object.
A light-proof rope bag provides good protection.
To clean the rope, rinse it with lukewarm water and
wipe with a damp cloth. The damp rope must be
dried before storage. The rope should be left to dry
naturally and not close to a fire or other sources of
heat.
5
Werbung
