Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GENERAL / USE
WARNING
This product may be utilized only by persons
trained in its safe use and having the relevant
knowledge and skills, or under the direct supervisi-
on of such persons. Whenever possible, the equip-
ment should be provided personally to the user. It
may be used only within the specified limited scope
of use and for the defined purpose.
Prior to using this product, read this document
thoroughly, make sure you understand the User
Instructions, and keep them with the product,
together with the Inspection Sheet! Keep in-
structions for future reference. In addition, check
national safety regulations regarding personal pro-
tective equipment (PPE) use for local requirements.
The product accompanied by this set of instructions
is type-examinde, CE-marked to state conformity
with the European directive 89/686/EEC on Perso-
nal Protective Equipment (PPE) and meets the Eu-
ropean standard(s) given ont the product Label. The
product does however not comply with any other
standards, in particular the product does not com-
ply with any American standards (like ANSI) unless
explicitly stated.
If the system is sold or passed on to another user,
the User Instructions must accompany the equip-
ment. If the system is transferred to another coun-
try, it is the responsibility of the seller/previous user
to ensure that User Instructions are in the correct
language for that country.
TEUFELBERGER is not responsible for any direct,
indirect, or incidental consequences/damage oc-
curring during or after the use of the product and
resulting from any improper use, especially caused
by incorrect assembly of the equipment.
Edition 03/2015, Art. no.: 6800501
EXPLANATION OF THE MARKING
Product name
A xxx
Type, diameter in mm, (example: A 10.5 =
Type A rope, 10.5 mm diameter)
EN 1891:1998 Standard for low stretch kernmantle
ropes
Lfd. Nr.: Year of manufacture, - serial number
CE 0408 CE confirms that the basic requirements
of 89/686/EEC (personal protection equip-
WARNING
The use of our products can be dangerous. Our products may only be used for their intended purpose. They
must particularly not be used for lifting as specified in EU directive 2006/42/EC. The customer is responsi-
ble that the user has been trained in the safe use of the product and in accompanying safety precautions.
Be aware of the fact that the product can cause damage if wrongly used, stored, cleaned or overloaded.
Check national safety regulations, industry recommendations and standards for local requirements.
TEUFELBERGER and 拖飞宝 are internationally registered trademarks of TEUFELBERGER Ges.m.b.H. Austria.
4
ment) are complied with. The number
identifies the inspection institute (0408
for TÜV Austria Services GmbH, Kruger-
strasse 16, A-1015 Vienna).
Manufacturer
Information that the User Instructions have
to be read.
The European standard symbols for washing and
care instructions of textiles are used.
Sections of the low stretch kernmantel ropes must
be marked at both ends with outer strips stating:
Type (A or B), diameter in mm, number of the stan-
dard (EN 1891).
USE
Ropes to EN 1891 are for use in systems to EN 341
(descender devices), EN 358 (positioning systems)
or EN 363 (fall arrest systems), i.e. for various types
of rope-assisted work.
Please bear in mind that new, unused ropes may
have a very smooth and even slippery surface.
When using them in combination with devices, be
sure to observe the respective manufacturer's infor-
mation for the device.
IMPORTANT! High friction of the rope on a metal
part (e.g. in excessively fast abseiling procedures)
or of the rope on a rope or other textile material
may cause overheating, damage to, and even ruptu-
ring of the rope.
End connections for Fides III 9.6 mm, Fides III 10.5
mm, Fides III 11 mm, Patron 10 mm, Patron PLUS
10 mm, Patron 10.5 mm, Patron PLUS 10,5 mm,
Patron 11 mm, Patron PLUS 11 mm, Patron 11 mm
treeACCESS, Patron 12 mm are supplied by us
sewn or attached by means of figure of eight knots,
all further ropes attached by means of figure of
eight knots. If you wish to make the end connec-
tions yourself, we recommend the use of figure
of eight knots.
A sufficiently long rope end (10cm min.) must re-
main after the knot.
Form the figure 8 knot correctly as shown below!
Mind the course of the load bearing rope section
(arrow). Deviating knot design considerably reduces
the breaking load.
Werbung
