Endress+Hauser RID16 Bedienungsanleitung Seite 40

Operating the field indicator
Electrical connection
Has the max. length of the fieldbus cable, as defined in the fieldbus specifications, been
observed?
Has the max. length of the spurs, as defined in the fieldbus specifications, been
observed?
Is the fieldbus cable completely shielded (90%) and correctly grounded?
6 Operating the field indicator
6.1 Quick operation guide
Operators have two options for configuring and commissioning the device:
1. Configuration programs
Device-specific parameters are configured via the E+H Service interface (CDI). A special device
driver (DTM) for an FDT operating program (e.g. DeviceCare, FieldCare) is available for this
purpose →  42.
The DTM file is available for download via: www.endress.com/download → Enter product root
→ Media type "Software" and "Device drivers".
2. Miniature switches (DIP switches) for local configuration
You can make the following settings for the fieldbus interface using miniature switches (DIP
switches) on the electronics module →  43:
• Setting to specify whether operation is possible via DIP switches or remotely via the DTM
• Setting for the address of the bus users whose values are to be displayed
• Configuring an offset
40
RID16
Notes
see cable specifications in
the Operating Instructions
Endress+Hauser