Endress+Hauser RID16 Bedienungsanleitung Seite 33

RID16
4.4 Post-installation check
After installing the device, always run the following final checks:
Device condition and specifications
Is the device damaged?
Is the seal undamaged?
Is the device securely fastened to the wall or the mounting plate?
Is the front of the housing securely closed?
Does the device correspond to the measuring point specifications, e.g. ambient
temperature range etc.?
5 Wiring
WARNING
L
Danger of explosion if unit is connected incorrectly in hazardous area
‣
When connecting Ex-approved devices please take special note of the instructions and
connection schematics in the Ex-specific supplement to these Operating Instructions. If you
have any questions, please do not hesitate to contact your E+H representative.
NOTICE
Electronics can be destroyed if unit is connected incorrectly
‣
Switch off power supply before installing or connecting the device. Failure to observe this
may result in destruction of parts of the electronics.
‣
The post connector is only used to connect the display. If other devices are connected, this
can result in the destruction of parts of the electronics.
Devices can be connected to the PROFIBUS® PA in two ways:
• Via a conventional cable gland
• Via a fieldbus connector (optional, available as an accessory)
Endress+Hauser
Wiring
Notes
Visual inspection
Visual inspection
-
-
See ' T echnical data' section
33