Endress+Hauser RID16 Bedienungsanleitung Seite 35

RID16
5.1.2 Procedure to wire the field indicator
 6 Opening the housing of the field indicator
1 Internal ground terminal (only aluminum housing)
1. Open the cable gland and open the housing cover.
2. Guide the cable through the cable gland.
3. Connect the cable →  8,  36
4. Install cable screen clamps (aluminum housing only) →  7,  35
5. Tighten the cable gland again and close the housing cover.
6. To avoid any mistakes when connecting the unit, note the instructions in the "Post-
connection check" section.
 7 Installation of the cable screen clamps (aluminum housing only)
Endress+Hauser
+ -
1
Wiring
A0011636
A0014935
35