Endress+Hauser RID16 Bedienungsanleitung Seite 41

RID16
 11 Hardware setting via DIP switches
1 ON switch position
2 OFF switch position
3 Write protection
Only 2 display values can be configured when operating via the DIP switches.
6.1.1 Listener mode
The field indicator acts solely as a listener, i.e. it does not appear in the bus as an active user
with its own specific address and it also does not increase the traffic in the bus.
The field indicator analyzes the devices active on the bus. Via their addresses these devices
can be assigned to up to 8 channels if DTM operation is used, or up to 2 channels in the case
of operation with DIP switches.
Operation via the PROFIBUS protocol is not possible given the sole listener function of
the indicator!
Endress+Hauser
1
2
Operating the field indicator
3
A0021500
41