Carl Valentin ILX 56/8 Kurzanleitung Und Hinweise Zur Produktsicherheit Seite 109

Unpack the Printing System

Lift the printing system on the bottom and remove it from the carton.

Check the printing system for transport damages.

Remove the foam transportation safeguards near the printhead.

Check delivery for completeness.
Scope of Delivery
•
Printing system.
•
Power cable.
•
Empty core, mounted on transfer ribbon rewinder.
•
Dispensing edge.
•
Product Safety Guide.
NOTICE!
Retain the original packaging for subsequent transport.
Set up the Printing System
CAUTION!
The printing system and the print media can be damaged by moisture and water.

Set up the printing system only in a dry place protected from sprayed water.
Connect the Printing System
The printing system is equipped with a versatile power supply unit. The device may be operated with a mains voltage of
110 ... 230 V AC / 50-60 Hz without any adjustments or modifications.
CAUTION!
The printing system can be damaged by undefined switch-on currents.

Set the power switch to '0' before plugging in the printing system.

Insert the power cable into the power connection socket.

Insert the plug of power cable into a grounded electrical outlet.
NOTICE!
Insufficient or missing grounding can cause faults during operation.
Ensure that all computers and connection cables connected to the printing system are grounded.

Connect the printing system to a computer or network with a suitable cable.
Initial Operation of the Printing System

After all connections are completed, switch on the printing system.

Insert label material and transfer ribbon.

Start measuring in menu Label layout/Measure label.

Press the key to finish measuring.
NOTICE!
To enable correct measuring, at least two completed labels have to be passed through (not for continuous labels).
During measuring the label and gap length small differences can occur. Therefore the values can be set manually in menu
Label layout/Label and gap.
English
ILX
109