Carl Valentin ILX 56/8 Kurzanleitung Und Hinweise Zur Produktsicherheit Seite 106

ILX
Operating Conditions
Before initial operation and during operation these operating conditions have to be observed to guarantee save and
interference-free service of our printing systems.
Therefore please carefully read these operating conditions.
As the delivery is customised, please compare the supplied accessories with your order.
General Conditions
Shipment and storage of our printing systems are only allowed in original packing.
Installation and initial operation of our printing systems is only allowed if operating conditions were fulfilled.
Initial operation, programming, operation, cleaning and service of our printing systems are only recommended after careful
study of our manuals.
Operation of the printing system is only allowed by especially trained persons.
NOTICE!
Perform trainings regularly.
Content of the training are the chapters 'Operating Conditions', 'Loading Media' and 'Maintenance and Cleaning'.
These indications are also valid for someone else's equipment supplied by us.
Only use original spare and exchange parts.
Please contact the manufacturer with respect to spare/wear parts.
Conditions for Installation Place
The installation place of printing system should be even, free of vibration and currents of air are to be avoided.
The printing system have to be installed to ensure optimal operation and servicing.
Installation of Power Supply
The installation of the power supply to connect our printing system has to be effected according to the international rules and
regulations, especially the recommendations of one of the three following commissions:
•
International Electronic Commission (IEC)
•
European Committee for Electro technical Standardisation (CENELEC)
•
Verband Deutscher Elektrotechniker (VDE)
Our printing systems are constructed according to VDE and have to be connected to a grounded conductor. The power supply
has to be equipped with a grounded conductor to eliminate internal interfering voltage.
Technical Data of Power Supply
Power line voltage and power line frequency:
Allowable tolerance of power line voltage:
Allowable tolerance of power line frequency:
Allowable distortion factor of power line voltage:
Anti-Interference measures:
In case your net is infected (e.g. by using thyristor controlled machines) anti-interference measures have to be taken. You can
use one of the following possibilities:
•
Provide separate power supply to our printing systems.
•
In case of problems please connect capacity-decoupled isolation transformer or similar interference suppressor in front of
our printing system.
106
see type plate
+6 % ... −10 % of nominal value
+2 % ... −2 % of nominal value
≤ 5 %
English