Parkside PLV 1500 B1 Originalbetriebsanleitung Seite 34

GB IE
We cannot be held liable for damage
caused by our implements if they were
improperly repaired, if non-original parts
have been used or if they were used not in
keeping with their intended purpose.
E
Exchanging the cylinder
Switch off the implement, discon-
nect the mains plug and wait until
the cylinder is standing still.
Wear gloves when handling the
cylinder.
1. Turn the implement over.
2. Loosen the wing screw (19) and pull
the bearing support upwards.
3. Lift the roller (
and pull the shaft out of the hexagon
receptacle (20)..
4. Insert the new cylinder (
reversing the sequence.
Storage
• Store the implement in a dry place well
out of reach of children.
• Allow the motor to cool down before
placing the implement in a closed
room.
• Do not wrap nylon sacks around the
implement as this could result in the
formation of moisture.
Without wall bracket:
To save space when stored, the
handlebar can be folded down af-
ter releasing the tightening levers.
Ensure that the cables are not
squeezed.
34
16/17) diagonally
A
16/17) by
A
With wall bracket:
You can suspend the folded-up device from
the wall using the wall bracket.
Screw the wall bracket (21) to the
wall with the enclosed screws (22),
using dowels (not included in deliv-
ery package) if necessary. Suspend
the device from the lower bar (6).
Check the tightness of the wall
bracket fi tting regularly.
Disposal and protection
of the environment
Dispose of the implement, accessories and
packaging in an environment-friendly man-
ner.
Electrically-powered appliances
must not be disposed of with the
domestic waste.
Hand in the spent implement to a recycling
centre. The plastic and metal parts can
then be sorted out and graded for recy-
cling. Our Service Center will be happy to
answer any questions in this respect.
Spare Parts/Accessories
Spare parts and accessories can
be obtained at
www.grizzlytools.shop
If you have issues ordering, please use
the contact form. If you have any other
questions, contact the service centre (see
"Service-Center" Page 36).