Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise Seite 90

[ 31 ]
Use the hex key
a counter-clockwise direction.
Remove the old sanding pad
Align the centre hole
pad with the spindle
38 ] [
Place the washer
[ 37 ]
screw .
[ 31 ]
Use the hex key
clockwise direction.
Replacing the carbon brushes
(Fig. S)
m WARNING!
u
Always replace both carbon brushes at the
same time.
u
Do not use accessories not recommended
by Parkside. Using incompatible carbon
brushes may result in electric shock,
personal injury or property damage.
Use the slotted screwdriver
carbon brush holder cap
clockwise direction.
Remove the carbon brush holder cap
spring of the carbon brush comes out.
Remove the carbon brush.
Insert the spare carbon brush
carbon brush holder.
Gently compress the spring of the carbon
34 ] [
brush using the carbon brush holder
6 ] [
cap until the spring is completely pushed
inside.
Use the slotted screwdriver
carbon brush holder cap
direction.
Repeat for the second carbon brush
the other side.
88 GB/MT
37 ] [
to loosen the screw
[ 2 ]
.
[ 39 ]
of the new sanding
[ 40 ]
.
on the thread of the
[ 37 ]
to fasten the screw
32 ] [
to loosen the
[ 6 ]
in a counter-
[ 6 ]
. The
[ 34 ]
into the
[ 32 ]
to fasten the
[ 6 ]
in clockwise
34 ] [
on
˜ Repair
in
This product does not contain any parts that can
be repaired by the user. Contact an authorised
service centre or a similarly qualified person to
have it checked and repaired.
m
WARNING! RISK OF INJURY!
in
u
If the power cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order
to avoid a hazard.
˜ Storage
Switch off the product and disconnect it from
the mains. Let the product cool down.
Clean the product as described before.
Store the product and its accessories in a
dark, dry, frost-free, well-ventilated place.
Always store the product in a place that is
inaccessible to children. The ideal long term
storage (longer than 3 months) temperature
is between +10 and +30 °C with a relative
humidity of max. 60 %.
˜ Transportation
Switch off the product and disconnect it from
the mains. Let the product cool down.
Protect the product from any heavy impact
or strong vibrations which may occur during
transportation in vehicles.
Secure the product to prevent it from slipping
or falling over.