Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise Seite 87

˜ Attaching and removing
sanding paper
(Fig. J)
Attaching: Align the holes on the sanding
33 ] [
paper with the holes on the sanding
[ 2 ]
pad . The holes allow the dust to be
extracted from the sanding guard
Press the sanding paper against the sanding
pad. The sanding paper is held in position by
the hook-and-loop fastener.
Removing: Peel off the edge of the sanding
[ 33 ]
paper . Pull the sanding paper off the
[ 2 ]
sanding pad .
˜ Function of the brush edge
(Fig. J)
[ 7 ]
The brush edge
2 ] [
sanding pad . The brush edge is the first
part to touch the surface to be sanded. This
allows the sanding pad to be positioned in
parallel to the surface before the sanding
33 ] [
paper touches the surface. This prevents
the formation of sickle-shaped recesses
caused by the edge of the rotating sanding
paper.
[ 7 ]
The brush edge
dust escaping from the sanding guard
Before each use: Check the brush
[ 7 ]
edge for damages. If the brush edge is
damaged or worn out, have it replaced by a
qualified person.
1 ] [
.
protrudes beyond the
prevents excessive sand
1 ] [
.
˜ Operation
˜ Connecting to power supply
NOTES
u
Before you connect the product to the
power supply, make sure that the data on
the rating plate are identical to the power
supply data.
u
Avoid long supply lines (extension cables).
u
Do not operate the product in a damp or
wet room.
u
The product may only be operated in
suitable rooms (well ventilated).
Connect the power plug
The product is now ready for use.
˜ Switching on and off
(Fig. K)
Switching on: Press and hold the
[ 19 ]
trigger .
Continuous operation: When the
19 ] [
trigger is pressed down, press the trigger
[ 18 ]
lock .
Switching off: Release the trigger
you locked the trigger, press it briefly.
15 ] [
to a socket-outlet.
19 ] [
. If
GB/MT 85