Parkside PWDS 920 B2 Bedienungs- Und Sicherheitshinweise Seite 88

˜ Adjusting the speed
(Fig. K)
NOTES
u
Adjust the speed, before you apply the
product to the surface.
u
Use a low speed for rough sanding. Use a
high speed for smooth finishing.
Increasing speed: Press the + button
Reducing speed: Press the – button
NOTE
u
After you switch off the product, the
[ 2 ]
sanding pad keeps on rotating for a
short while. Wait until the sanding pad
stops rotating, before you put the product
aside.
˜ Removing and attaching the
detachable front guard cover
(Fig. L)
NOTE
u
You can remove the detachable front guard
[ 3 ]
cover , if you want to apply the product
closer to the wall/ceiling.
Removing: Slightly press down the front
4 ] [
guard cover lock
Pull the detachable front guard cover
the sanding guard
Attaching: Reattach the detachable front
3 ] [
guard cover to the sanding guard
The front guard cover lock
place.
86 GB/MT
[ 17 ]
[ 16 ]
.
[ 3 ]
off
1 ] [
.
1 ] [
.
[ 4 ]
must click into
˜ Switching the LED working
lamp on and off
(Fig. M)
Switching on: Press the LED working lamp
12 ] [
switch down into the I position.
Switching off: Press the LED working lamp
[ 12 ]
switch down into the O position.
˜ Rotating and tilting the motor
.
housing
.
(Fig. N, O)
NOTE
u
By rotating and tilting the motor housing
you can maximise the accessibility to the
working surface. This allows the sanding
2 ] [
pad to follow the contours of the
working surface.
You can rotate the motor housing
left and right by up to 30°.
You can tilt the motor housing
by up to 30°.
You can tilt the motor housing
by up to 90°.
˜ Working instructions
Select and attach a sanding paper
Switch on the product and adjust the speed.
Wait until the product has reached the set
speed.
Hold the sanding pad
working surface. Touch the working surface
with the brush edge
Apply some pressure so that the sanding
[ 33 ]
paper touches the working surface.
[ 5 ]
[ 5 ]
to the
5 ] [
to the front
5 ] [
to the back
33 ] [
.
2 ] [
parallel to the
[ 7 ]
.