Herunterladen Diese Seite drucken

Elite REALAXIOM B+ Bedienungsanleitung Seite 34

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 36
EN
on the inside. The warranty is invalidated if the
unit is opened or tampered with.
• Since the feet are made from soft non-slip ma-
terial, during use they may leave rubber marks
on the floor.
• During use of the
roller, slight wear of the roller is to be considered
normal. Tests carried out at Elite show that after
continuous use for 20.000 km, roller wear is around
0.1 mm, and as the total thickness is 15 mm, far
greater wear does not prevent correct operation of
the trainer. Claims due to improper or careless use
will not be acknowledged. Possible slight wear of
the rubber part comes within the norm.
• Use with narrow tyres or with non-optimum
tyre pressures can permanently damage the
Elastogel roller.
• Pay attention to the pressure between tyre and
roller: tighten the plate adjustment screw three
• For less tyre wear and better grip on the roller,
it is advisable to use tyres of 23 mm width.
• Recommended rear wheel pressure: 7 -8
atmospheres for racing tyres; 3.5 - 4 atmosphe-
res for MTB tyres. For particular cases, comply
with the pressure recommended by the tyre
manufacturer.
• For quieter use, better grip of the tyre on the
roller and reduced vibration, use slick tyres (also
for Mountain bikes).
• Before use, clean the tyre with alcohol or water.
• If the pin of the quick release supplied protrudes
more than 3 mm from the fixing nut, cut off the
protruding part (fig. 45).
30
with Elastogel
RealAxiom B+
ADVICE:
complete turns from when the roller touches the
tyre. If the tyre still slips on the roller, tighten
the screw another turn and make the pressure
on the pedal more progressive. Training with the
tyre slipping will permanently damage the Ela-
stogel roller and the tyre.
• The console that is fitted on the handlebar is not
waterproof. Take care not to sweat over the con-
sole, as the sweat could damage the electronic
circuit.
• Do not keep the
RealAxiom B+
places. This could damage the electronic com-
ponents.
• The conformity of the RealAxiom B+ to the Council
Directives (ref. "Declaration of Conformity" at page
) could be compromised if not used with the sup-
76
plied power adaptor (ref. Q).
• Never exceed the MIN level of the feet regu-
lator.
in wet or damp

Werbung

loading